Coil to Coil Machines

• No coolant water pit needed
• No heavy foundation required
• Reusable clean scrap
• Good reliable service
• High productivity
• Close tolerances ISO h9 (Cpk = 1.33) are maintained

• Low operating cost
• Excellent surface finish
• Quick set-up time
• Self-centering material entry and exit guides
• Excellent vibration damping

• Wire throughfeed speed up to 600 ft/min (180m/min)
• Material removal in diameter: up to 4%
• Stationary die broacher (shaver) with rotating chip breaker

• Chip breaker blades rotate around the carbide cutting die to prevent any tangling of the removed material as well as to prevent any obstructing of the die shaver opening.

13mm to 38mm